Revamp issues

Post Reply
dan.cojocaru
Posts: 13
Joined: Thu Apr 06, 2017 10:52 am
Contact:

Revamp issues

Post by dan.cojocaru » Sat Mar 18, 2017 9:23 am

Hi all,

I would like to have your feedback regarding issues that you faced after a revamp or modification on your plant and how did you overcome these issues?
It was about learning the new process? Or perhaps miss-alignments between new and old technology?
We are preparing now several risk registers with focus on engineering, commissioning and operation and the risks associated with revamps are key elements in these risk registers.

Your feedback is highly appreciated.

rupesh sawant
Posts: 1
Joined: Thu Apr 06, 2017 10:52 am

Re: Revamp issues

Post by rupesh sawant » Wed Jun 07, 2017 1:55 pm

Dear Dan,
During revamp major challange to operation person is process safety margins.
The detail Engg contractor plays with the process margins which were considered during Basic engg.
After revamp specially if capacity is above 150% of original the process tolerance becomes very low.

Post Reply